A 3D printed case for the Cardputer ADV
While scrolling on reddit last year, I discovered the existence of the M5 Stack Cardputer device with the promise to be a cheaper alternative to the Flipper zero.
I ordered one on AliExpress and installed the bruce firmware once received. I was amazed how this little device and this OSS code would be able to do out of the box. I found a nice 3D printed case on printables from hippazoid that matched perfectly the device.
Later on, I ordered the Cardputer ADV to take advantages of the new pin-out system. I printed a second case without realising that the case was not compatible with the ADV version.
That was the opportunity to test FreeCAD and adapt the model to fit the new version.
I recreated the lid and the bottom part from the measurements of the original model using the measurement tool from BambuStudio. To adapt the bottom part, I used measurements from this ADV stand model from printables.com
You can find the models here: